Gardena 3000/4 Jet Manual de Instruções - Página 5

Procurar online ou descarregar pdf Manual de Instruções para Bomba de água Gardena 3000/4 Jet. Gardena 3000/4 Jet 12 páginas. Garden pump
Também para Gardena 3000/4 Jet: Manual de Instruções (16 páginas), Manual de Instruções (16 páginas)

Imprimir página

4. Operation

Filling the pump:

5. After Operation

Overwintering/Storage:

Disposal:

(in accordance with

directive 20002/96/EC)

DANGER ! Electric shock !

Risk of injury due to electric shock.

➔

Disconnect from the mains before filling the

Garden Pump.

ATTENTION! Dry-Running

➔

Before each operation, fill the pump to over-

flowing with approx. 2 to 3 l of the liquid to be

pumped!

1. Unscrew the screw fitting

2. Fill the pump via the filler cap

2 to 3 l of the liquid to be pumped.

3. Tighten the screw fitting

use pliers).

4. Open all possible shut-off devices in the pressure line

(watering accessories, Water Stop, etc.).

5. Drain remaining water

hose so that air can escape during

the suction process.

6. Set On/Off switch

position.

7. Plug the pump into a 230 V / 50 Hz

alternating current socket.

8. Set On/Off switch

position.

9. Hold the pressure hose

pump until the pump begins to pump.

➔ If the pump does not deliver liquid after ca. 5 minutes, set

the On/Off switch g) to position „0" (see 7. Trouble-

Shooting).

The specified maximum self-priming height of 7 m is only achie-

ved if the pump is filled via the filler neck

if the suction hose

is held as high as possible while filling and

during the self-priming procedure so that no liquid can escape

from the pump via the suction hose

Before the start of the frost period the Garden Pump should be

stored protected from frost.

1. Open the water drain screw

The Garden Pump drains.

2. Store your Garden Pump so that it is protected from frost.

The unit must not be disposed of with normal household waste but

must be disposed of in accordance with local environmental

regulations.

of the filler cap

to overflowing with approx.

of the filler cap

in pressure

to position „0"

to position „1"

approx. 1-2 m vertically above the

until it overflows and

by hand.

by hand (do not