Gardena 3000/4 Jet Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Водяной насос Gardena 3000/4 Jet. Gardena 3000/4 Jet 12 страниц. Garden pump
Также для Gardena 3000/4 Jet: Руководство по эксплуатации (16 страниц), Руководство по эксплуатации (16 страниц)
Печатать страницу
4. Operation
Filling the pump:
© © ©
©
© © ©
© © ©
©
©
5. After Operation
Overwintering/Storage:
©
Disposal:
(in accordance with
directive 20002/96/EC)
DANGER ! Electric shock !
Risk of injury due to electric shock.
➔
Disconnect from the mains before filling the
Garden Pump.
ATTENTION! Dry-Running
➔
Before each operation, fill the pump to over-
flowing with approx. 2 to 3 l of the liquid to be
pumped!
1. Unscrew the screw fitting
2. Fill the pump via the filler cap
2 to 3 l of the liquid to be pumped.
3. Tighten the screw fitting
use pliers).
4. Open all possible shut-off devices in the pressure line
(watering accessories, Water Stop, etc.).
5. Drain remaining water
hose so that air can escape during
the suction process.
6. Set On/Off switch
position.
7. Plug the pump into a 230 V / 50 Hz
alternating current socket.
8. Set On/Off switch
position.
9. Hold the pressure hose
pump until the pump begins to pump.
➔ If the pump does not deliver liquid after ca. 5 minutes, set
the On/Off switch g) to position „0" (see 7. Trouble-
Shooting).
The specified maximum self-priming height of 7 m is only achie-
ved if the pump is filled via the filler neck
if the suction hose
is held as high as possible while filling and
during the self-priming procedure so that no liquid can escape
from the pump via the suction hose
Before the start of the frost period the Garden Pump should be
stored protected from frost.
1. Open the water drain screw
The Garden Pump drains.
2. Store your Garden Pump so that it is protected from frost.
The unit must not be disposed of with normal household waste but
must be disposed of in accordance with local environmental
regulations.
of the filler cap
to overflowing with approx.
of the filler cap
in pressure
to position „0"
to position „1"
approx. 1-2 m vertically above the
until it overflows and
.
.
by hand.
by hand (do not
©
13