ALIGNER CCD2.0WIFI Instalação e manual - Página 8

Procurar online ou descarregar pdf Instalação e manual para Equipamento de teste ALIGNER CCD2.0WIFI. ALIGNER CCD2.0WIFI 16 páginas.

4 THE "connect" WIFI NETWORK

4.1 Description and Configuration

The WiFi network of the CCD2.0WiFi set‐up essentially consists of the 2 front detectors connected to the

"connect" SSID generated by the access point and the tablet also connected to the "connect" SSID.

It is possible to connect the Detectors and the Tablet to a different SSID, useful if for example there are

multiple CCD2.0WiFi settings in the same room.

To change the name of the SSID on the Access Point, refer to the instructions provided by the

manufacturer.

To set the front detectors so that they automatically connect to the different SSID, it is necessary to

proceed as follows:

‐

Initialise the detectors with the Reset procedure ‐ see chap. 4.2

‐

Configure the chosen SSID on the detectors ‐ see chap. 4.3

4.2 Initialisation of the front WIFI detectors

To initially set up the "CCD‐WIFI" front detectors (Reset WIFI

procedure), operations must be carried out manually using the

appropriate keypad.

The operations to be performed are illustrated in sequence

below:

- Press the F2

and F3

- Press the F4 key

- Press the F5 key

the red LED flashes faster, at the end the LED stays on permanently.

- Switch off the detector with the F1

Page 6/14

keys simultaneously

3 times; the red LED in this phase flashes.

to confirm, wait a few seconds for Reset of the WIFI module; during this phase

and F4

SSID = connect

Figure 10

keys.

Cod. R0368 ‐ rev.1.0

R0368

(03/2020)