2N EasyGate Pro Início rápido - Página 4

Procurar online ou descarregar pdf Início rápido para Porta de entrada 2N EasyGate Pro. 2N EasyGate Pro 4 páginas. Umts gateway
Também para 2N EasyGate Pro: Início rápido (4 páginas), Início rápido (2 páginas), Início rápido (4 páginas)

Imprimir página

• If the called subscriber is available, you

can hear the ringing tone. If not, you can

hear the busy tone or any of the GSM

provider's messages.

• When the called subscriber answers the

call, the call is established. The Line LED

is permanently on during the call.

• Hang up to terminate the call. The Line

LED goes off. If the called subscriber is

the first to hang up, you can hear the

busy tone and hang up.

Incoming call

• An incoming call is signaled by ringing.

The Line LED flashes during ringing.

• Hook off the phone to establish the call.

The Line LED is permanently on during

the call.

• For call termination see the Outgoing call

section.

Fax and modem connection

(fax models only)

EasyGate with fax converter has ability to

manage fax messages using analogue fax

Group 3 and data connection using analog

modem connected to telephone line. The

fax or data service must be registered with

your GSM operator.

• Outgoing FAX call or Data connection

Before

destination

*01* for fax call or *02* for data call.

When connected device generates calling

tone, this preset is not necessary.

In the GSM network, GPRS data transfer is suspended during voice calls

and do not continue until the voice call is finished.

EU Declaration of Conformity

Hereby, 2N TELEKOMUNIKACE a.s. declares that the radio equipment type 2N

compliance with directives 2014/53/EU and 2011/65/EU. The full text of the EU declaration of

conformity is available at the internet address www.2n.com.

number

dial

code

• Incoming FAX call or data connection

It is recommended to activate separate

fax

number

multinumbering

messages and data connection should be

routed to appropriate number. If the fax

or data number is not activated, the call

from analogue network is not detected as

fax or data call and is routed via the

analogue channel of GSM network, the

connection can´t be established. In this

case it is possible to set fax engine in the

gateway to receive the next call as fax or

data

call

–

wiki.2n.com.

guaranteed by all operators.

Configuration over USB

• For

PC configuration of

necessary

Connect EasyGate to PC using USB cable.

• Virtual serial port(USB serial port FTDI) is

created immediately after linking PC and

EasyGate.

This

PCManager

EasyGate. When the port isn't activated

automatically use driver at www.2n.com.

• The COM port number of virtual serial

port has to be set in PCManager.

• USB

port

can

communication (CSD, GPRS) directly over

GSM module.

• Detailed description of configuration and

data communication is in the product

manual on wiki.2n.com.

your

SIM

scheme.

see

the

manual

This

function

EasyGate

install

PCManager UNI.

port

used

communicate

used

for

EasyGate is in

card

–

Fax

not

with

data