Brother CP-2000 Manual do utilizador - Página 10

Procurar online ou descarregar pdf Manual do utilizador para Software Brother CP-2000. Brother CP-2000 33 páginas. Copyboard
Também para Brother CP-2000: Manual do utilizador (19 páginas), Brochura e especificações (4 páginas), Lista de referência de peças (18 páginas)

Imprimir página
Brother CP-2000 Manual do utilizador
2. Setup
After folding up the stand, the CP2000 can be carried using the handle on the back.
a
Be sure to use the handle to transport the
copyboard. Do not transport the unit by
carrying it by its stand, otherwise the stand
may open up and the copyboard may fall
down.
c
b
While transporting the copyboard, be careful
not to drop it, scratch it, or hit it against
anything.
Wall mounting
With the enclosed wall-mounting bar and brackets, the copyboard can easily be mounted
on a wall. In addition, by installing the printer on either a short or long edge of the
copyboard, the unit can be positioned either vertically or horizontally.
Attaching the wall-mounting bar
Follow the precautions below to mount the copyboard correctly on the wall
and reduce the risk of it falling down.
a
Use the enclosed anchors to attach the wall-mounting bar to plasterboard that is
at least 0.5 in. to 0.63 in. (12.7 mm to 15.9 mm) thick. When mounting the
copyboard on other types of walls, consult with a contractor first and be sure to
use the appropriate types of screws.
Make sure that there is no metal, wood, or wires behind the wall at the points
where the anchors will be installed.
+
Before mounting the copyboard on the wall, set it up on its stand and check that
it is operating correctly.
During installation, keep in mind that an anchor is difficult to remove once it has
been installed in the wall.
1
Hold the wall-mounting bar against the wall at the position where it
will be attached, making sure that it is level, and then mark the wall at
the four points where the anchors will be installed.
+
8
Be sure to attach the bar using either pair of holes A or B together with
either pair of holes C or D.
It is recommended that holes A and D be used. However, holes B and C
can be used if necessary.