Brother RuggedJet RJ-4040 Manual do utilizador - Página 31

Procurar online ou descarregar pdf Manual do utilizador para Software Brother RuggedJet RJ-4040. Brother RuggedJet RJ-4040 33 páginas. Mobile printer
Também para Brother RuggedJet RJ-4040: Manual de referência rápida (2 páginas), Manual do software (48 páginas), Manual de referência rápida (1 páginas), Manual do utilizador (34 páginas), Manual de Segurança do Produto (22 páginas)

Appendix B

Using BOOTP to configure the IP address

BOOTP is an alternative to RARP that has the advantage of allowing configuration of the subnet mask and

gateway. In order to use BOOTP to configure the IP address make sure that BOOTP is installed and running

on your host computer (it should appear in the /etc/services file on your host as a real service; type

man bootpd or refer to your system documentation for information). BOOTP is usually started up via the

/etc/inetd.conf file, so you may need to enable it by removing the "#" in front of the bootp entry in that

file. For example, a typical bootp entry in the /etc/inetd.conf file would be:

#bootp dgram udp wait /usr/etc/bootpd bootpd -i

Depending on the system, this entry might be called "bootps" instead of "bootp".

Note

In order to enable BOOTP, simply use an editor to delete the "#" (if there is no "#", then BOOTP is already

enabled). Then edit the BOOTP configuration file (usually /etc/bootptab) and enter the name, network

type (1 for Ethernet), MAC Address (Ethernet Address) and the IP address, subnet mask and gateway of

the print server. Unfortunately, the exact format for doing this is not standardized, so you will need to refer

to your system documentation to determine how to enter this information. Some examples of typical

/etc/bootptab entries include: ("BRN" below is "BRW" for a wireless network.)

BRN310107 1

00:80:77:31:01:07 192.168.1.2

and:

BRN310107:ht=ethernet:ha=008077310107:\ip=192.168.1.2:

Certain BOOTP host software implementations will not respond to BOOTP requests if you have not included

a download filename in the configuration file. If this is the case, simply create a null file on the host and specify

the name of this file and its path in the configuration file.

As with RARP, the print server will load its IP address from the BOOTP server when the printer is powered on.

The Brother print server supports the Automatic Private IP Addressing (APIPA) protocol. With APIPA, DHCP

clients automatically configure an IP address and subnet mask when a DHCP server is not available. The

device chooses it's own IP address in the range 169.254.1.0 through to 169.254.254.255. The subnet mask

is automatically set to 255.255.0.0 and the gateway address is set to 0.0.0.0.

By default, the APIPA protocol is enabled. If you want to disable the APIPA protocol, you can disable it using

BRAdmin Light or Web Based Management (web browser).