Fujitsu SK-96620_350-64PMC(1) Manual do utilizador - Página 38
Procurar online ou descarregar pdf Manual do utilizador para Placa-mãe Fujitsu SK-96620_350-64PMC(1). Fujitsu SK-96620_350-64PMC(1) 47 páginas. F²mc-16lx/fx family, mb96620/350 series, mb90350 series
Imprimir página
6.2.4 Flash Programming
The following procedure must be followed for Flash programming:
1. Power off the board
2. Configure the microcontroller mode:
3. Check the Jumper-settings according to the UART (chapters 4.10 and 4.11) and the
jumper settings below the DPI switch figures.
4. Configure the mode:
DEBUG I/F
MB96600
P17_0
DIP Switch:
Programming
Mode
1 2 3 4 5 6 7 8
Note: JP50 don‟t care, JP51A/B closed
Rule 9: By using a Serial Flash Programmer the jumper settings of JP50 and JP51A/B
must be considered.
Rule 10: Use serial 1:1 cable for connection between PC and starter kit.
5. Connect the configured UART (see above) to your serial PC communication port.
A straight 1:1 cable connection has to be used.
6. Power-on the board again.
© Fujitsu Semiconductor Europe GmbH
SK-96620_350-64PMC(1) User Guide
Chapter 6 Programming the internal Flash Memory
MD
nc
P00_1
nc
nc
nc
- 38 -
MD0
MB96300
MD1
On
Off
1 2 3 4 5 6 7 8
Note: JP50, JP51A/B closed
MD0
MD2
16LX
MD1
1 2 3 4 5 6 7 8
Note: JP50, JP51A/B closed
MD2
nc
P00_1
nc
nc
nc
nc
P00_1
nc
nc
P00_0
UG-960028-12
On
Off
On
Off