AEG 502 D Instruções de utilização e de instalação - Página 4
Procurar online ou descarregar pdf Instruções de utilização e de instalação para Campânula de ventilação AEG 502 D. AEG 502 D 20 páginas. Electrolux extractor hood installation and operating instructions
Também para AEG 502 D: Manual de instruções de instalação e funcionamento (16 páginas)
Imprimir página
Electrical connections
Safety
It must be ensured that the voltage and current indicated on the
warnings for
rating plate agree with the voltage of the user to electricity supply.
electrician
If the appliance has been equipped with a mains lead with a
moulded-on type plug, the following regulations must be comply
with:
The plug moulded on to the lead incorporates a fuse. For replace-
ment, use a 5 amp BS1362 fuse. Only ASTA approved or certified
fuses should be used. If the fuse cover/carrier is lost, a replace-
ment cover/carrie must be obtained from an electrical goods
retailer. If the socket outlets are not suitable for the plug fitted to
the appliance, then the plug must be cut off and destroyed for
safety reasons, and an appropriate plug be fitted.
When wiring the plug ensure that all strands of wire are securely
retained in each terminal. Do not forget to tighten the mains lead
clamp on the plug.
Electrical connections
230 V - using fixed power supply line with plug.
240 V - using fixed power supply line (Great Britain).
Fuse rating
13 amps
(The unit should only be connected up by an authorized electrician).
See rating plate for further information.
It is recommended that the socket for the plug is sited above the
cooker hood or above the overhead cabinet.
This has 2 advantages:
1) The socket is not visible.
2) The appliance can easily be unplugged when necessary.
If a fixed connection is required the cooker hood should be
connected by an electrical installer registered with a competent
electricity company. An isolating device is to be provided on the
fixed wiring side. Switches with a contact opening of more than
3mm apply as isolating devices.
These include-automatic cut-out switches, fuses and contactors
(VDE 0730, s. 7, Part1).
4