AEG 502 D 작동 및 설치 지침 - 페이지 4

{카테고리_이름} AEG 502 D에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 502 D 20 페이지. Electrolux extractor hood installation and operating instructions
AEG 502 D에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (16 페이지)

페이지 인쇄

Electrical connections

Safety

It must be ensured that the voltage and current indicated on the

warnings for

rating plate agree with the voltage of the user to electricity supply.

electrician

If the appliance has been equipped with a mains lead with a

moulded-on type plug, the following regulations must be comply

with:

The plug moulded on to the lead incorporates a fuse. For replace-

ment, use a 5 amp BS1362 fuse. Only ASTA approved or certified

fuses should be used. If the fuse cover/carrier is lost, a replace-

ment cover/carrie must be obtained from an electrical goods

retailer. If the socket outlets are not suitable for the plug fitted to

the appliance, then the plug must be cut off and destroyed for

safety reasons, and an appropriate plug be fitted.

When wiring the plug ensure that all strands of wire are securely

retained in each terminal. Do not forget to tighten the mains lead

clamp on the plug.

Electrical connections

230 V - using fixed power supply line with plug.

240 V - using fixed power supply line (Great Britain).

Fuse rating

13 amps

(The unit should only be connected up by an authorized electrician).

See rating plate for further information.

It is recommended that the socket for the plug is sited above the

cooker hood or above the overhead cabinet.

This has 2 advantages:

1) The socket is not visible.

2) The appliance can easily be unplugged when necessary.

If a fixed connection is required the cooker hood should be

connected by an electrical installer registered with a competent

electricity company. An isolating device is to be provided on the

fixed wiring side. Switches with a contact opening of more than

3mm apply as isolating devices.

These include-automatic cut-out switches, fuses and contactors

(VDE 0730, s. 7, Part1).