AEG 8290 D Manual de operação e instalação - Página 12
Procurar online ou descarregar pdf Manual de operação e instalação para Campânula de ventilação AEG 8290 D. AEG 8290 D 16 páginas. Cooker hood
Também para AEG 8290 D: Instruções de utilização e de instalação (20 páginas)
Imprimir página
Mounting the cooker hood - Fig. 7
Position the template on the wall and mark the position, and drill the holes (2
x Ø 8 mm).Mount the two rawl plugs with the hooks (3)
Hang the hood on the hooks and level it with the adjustment screws (4)
Remove the grease filters (5) and mark for the two screws (6). Remove the hood
and drill the holes (2 x Ø 8 mm).
Insert the rawl plugs (7) and hang the hood on the wall again. Adjust it
horizontally with the screws (8) and secure it with the screws (9)
Mount the chimney holder (10) with the rawl plugs (12) and the screws (11).
Be careful that it is centered over the hood and horizontally aligned.
Fitting for ducting (S)
Connect a tube between the hood air outlet and the wall or roof exhaust
channel. Fix it with the tube clamps supplied.
Fitting for recirculation (K)
Mount the recirculation spigot with the two screws supplied.
Mounting the chimney
Place the chimney (15) and fix it to the top chimney holder with the two
screws (16) supplied. Lower the bottom part of the chimney (17) and fasten
it to the top of the hood with two screws, supplied.
Note that the top part of the chimney can be mounted with the side grids up
or down. For use as a recirculation hood it must be mounted with the grids
upwards. (Fig. 6).
Fig. 6
12