AEG CHDD 8795 Manual de operação e instalação - Página 6

Procurar online ou descarregar pdf Manual de operação e instalação para Campânula de ventilação AEG CHDD 8795. AEG CHDD 8795 17 páginas. Electrolux cooker hood range hood models dd 8794 dd 8795 chdd 8795 operating and installation instructions
Também para AEG CHDD 8795: Instruções de utilização e de instalação (18 páginas), Manual de operação e instalação (22 páginas), Instruções de utilização e de instalação (22 páginas)

Control Panel

• Best results are obtained by using a low speed for normal conditions

and a high speed when odours are more concentrated.

Turn the hood on a few minutes before you start cooking, you will

then get an under pressure in the kitchen. The hood should be left on

after cooking for about 15 minutes or until all the odours have

disappeared.

• The hood operation may be controlled via the control ball or with the

remote control (the remote control is a special accessory and is

ordered separately).

Every status change (changing speed, switching on the lights, etc.)

and is recognizable from the variation of light emitted by the control

ball and by an acoustic signal.

The control ball is located below on the right side of the cooker hood.

The control ball serves also as a light signal :

• No signal :

The hood is switched off.

• Static green light :

Hood is switched on at power level 1 (minimum).

• Static orange light :

Hood is switched on at power level 2 (medium).

• Static red light :

Hood is switched on at power level 3 (maximum).

• Alternating red light :

Hood is switched on at intensive power level (timed at 5 minutes)

• Alternating green light :

Indicates the grease filter saturation - clean the grease filter

• Alternating orange light :

Indicates the charcoal filter saturation - clean or replace the

charcoal filter.

Attention!

The control Ball flashes orange to indicate the saturation of the odor

filter even when the charcoal filter is not installed inside the cooker

hood.

However perform the signal reset operation as follows: select the

intensive speed (the control ball lights up with a red flashing light),

depress again and hold depressed for about 3 seconds until a 'bip'

sound indicates the reset.