AEG CHDD 8795 Kullanım ve Kurulum Kılavuzu - Sayfa 6
Havalandırma Davlumbazı AEG CHDD 8795 için çevrimiçi göz atın veya pdf Kullanım ve Kurulum Kılavuzu indirin. AEG CHDD 8795 17 sayfaları. Electrolux cooker hood range hood models dd 8794 dd 8795 chdd 8795 operating and installation instructions
Ayrıca AEG CHDD 8795 için: Çalıştırma ve Kurulum Talimatları (18 sayfalar), Kullanım ve Kurulum Kılavuzu (22 sayfalar), Çalıştırma ve Kurulum Talimatları (22 sayfalar)
Sayfayı Yazdır
Control Panel
• Best results are obtained by using a low speed for normal conditions
and a high speed when odours are more concentrated.
Turn the hood on a few minutes before you start cooking, you will
then get an under pressure in the kitchen. The hood should be left on
after cooking for about 15 minutes or until all the odours have
disappeared.
• The hood operation may be controlled via the control ball or with the
remote control (the remote control is a special accessory and is
ordered separately).
Every status change (changing speed, switching on the lights, etc.)
and is recognizable from the variation of light emitted by the control
ball and by an acoustic signal.
The control ball is located below on the right side of the cooker hood.
The control ball serves also as a light signal :
• No signal :
The hood is switched off.
• Static green light :
Hood is switched on at power level 1 (minimum).
• Static orange light :
Hood is switched on at power level 2 (medium).
• Static red light :
Hood is switched on at power level 3 (maximum).
• Alternating red light :
Hood is switched on at intensive power level (timed at 5 minutes)
• Alternating green light :
Indicates the grease filter saturation - clean the grease filter
• Alternating orange light :
Indicates the charcoal filter saturation - clean or replace the
charcoal filter.
Attention!
The control Ball flashes orange to indicate the saturation of the odor
filter even when the charcoal filter is not installed inside the cooker
hood.
However perform the signal reset operation as follows: select the
intensive speed (the control ball lights up with a red flashing light),
depress again and hold depressed for about 3 seconds until a 'bip'
sound indicates the reset.
57