Aqua Computer poweradjust 3 Manual do utilizador e de instalação - Página 14

Procurar online ou descarregar pdf Manual do utilizador e de instalação para Controlador Aqua Computer poweradjust 3. Aqua Computer poweradjust 3 20 páginas. Usb unit is a high power fan or pump controller for pcs

Imprimir página

aqua

computer

POWERADJUST 3

Select the desired mode of operation for the fan output below the diagram. If

"Manual fan settings" is selected, the fan output can be set to a fixed value. In

"Speed controlled" mode, you can set the desired rotation speed, the poweradjust

3 controller will regulate output power to keep the speed constant if technically

possible. In "Automatic temperature control" mode (Ultra version only), the fan

power will be dynamically adjusted depending on the current temperature sensor

reading.

9.2. Manual fan settings

When using manual mode, set the desired output power here.

9.3. Speed settings

When using the speed controlled mode, set the desired speed here. The controller

speed setting should not be changed in normal setups.

9.4. Automatic temperature control

When using the automatic temperature control mode, set the desired target tem-

perature. The controller speed setting should not be changed in normal setups.

9.5. Start boost and output settings

The start boost feature can be used to reliably power up a fan or pump connected

to the power output. If activated, the poweradjust 3 unit will set the output to the

configured power for the configured duration before switching to normal opera-

tion. Exception: If the power output is set to 0 % (either by manual setting or by au-

tomatic control), the start boost will not be activated even if speed signal and/or

flow signal should be missing. If this behavior is not suitable for your application,

make sure to use the "Hold minimum power" feature described in the next para-

graph!

When using the speed controlled mode or the automatic temperature control

mode, the output range can be limited in both directions ("Minimum

power"/"Maximum power"). The check box "Hold minimum power" determines

whether the output will be switched off for low temperature sensor readings (box

not checked) or remain active at the set minimum power/speed (box checked). Set

minimum power to a value at which the connected fan or pump reliably starts up.

10. Alarm configuration(aquasuite)

Select "Alarm configuration" from the device list for the device to be configured.

10.1. Speed signal/Output

Select the signal to be provided through the speed signal output. Available options

are the speed signal of a connected fan/pump or flow sensor or an artificial speed

- 14 -

Aqua Computer GmbH & Co. KG

Gelliehäuser Str. 1, 37130 Gleichen