Aqua Creek Revolution Manual - Página 5

Procurar online ou descarregar pdf Manual para Sistemas de elevação Aqua Creek Revolution. Aqua Creek Revolution 14 páginas.
Também para Aqua Creek Revolution: Manual (16 páginas)

Imprimir página

ADA Fixing Insert Installation (Commercial Applications)

1. Due to the indexed anchor and keyed base of the lift, we recommend installation of the fixing insert after

the concrete has cured and you are ready to install the lift into the anchor.

2. Place the main assembly in the anchor and turn until the locking pin on the shaft of the lift lines up and

drops into the locking pin slot in the anchor. DO NOT LIFT THE MAIN ASSEMBLY BY USING THE ELECTRIC

RAM AS A HANDLE. If the transport cart was ordered with the lift, it can be used effectively here. If not,

use two people.

3. Mark the location for the fixing anchor hole and remove the lift.

4. Drill the hole with a 1 1/4 inch core drill or roto-hammer to a depth of about 4 1/2 inches.

5. Clean the hole out and make sure it is dry. Thread the 1/2 inch bolt into the top of the PVC fixing anchor

and test fit to verify it can be mounted perpendicular. See Step 1 below.

6. Using a two part construction epoxy, fill the hole approximately half full and carefully insert the PVC fixing

anchor into the hole, twisting as you push down to evenly spread the epoxy.

7. Allow the epoxy to cure before securing the lift.

8. Re-install the lift into the anchor and using the 1/2 inch bolt and washer, carefully thread into the installed

anchor until snug. TO PREVENT BREAKING THE FIXING BRACKET, DO NOT OVERTIGHTEN!

1/2" X 2"

HEX BOLT

1/2" FLAT

WASHER

DECK

STEP 1

(see pg 4, FIGURE A)

MAIN ASSEMBLY

LOCKING PIN

POST

LOCKING SLOT

ANCHOR

Revised 8/11/16