Aqua Creek Revolution Manual - Página 7
Procurar online ou descarregar pdf Manual para Sistemas de elevação Aqua Creek Revolution. Aqua Creek Revolution 14 páginas.
Também para Aqua Creek Revolution: Manual (16 páginas)
Imprimir página
LIFTING
ARM
1/2" X 3"
SHOULDER
BOLT
STEP 5: ADJUST THE SEAT POSITION
The SEAT ASSEMBLY will arrive attached to the SEAT ARM
adjusted to its highest position. To adjust the SEAT ASSEMBLY
to a lower position remove the hardware as shown below.
Slide the SEAT ASSEMBLY to its desired position (in 4 inch
increments) and reinstall the hardware. The maximum
adjustment is 16 inch (down).
DO NOT ATTACH THE SEAT ASSEMBLY ANY LOWER THAN THIS
– ALWAYS USE THE TWO (2) SUPPLIED BOLTS TO ATTACH THE
SEAT ASSEMBLY TO THE CHAIR ARM!
NOTE: For most applications, such as pools with a flat deck,
the seat will be installed in its lowest position. For applications
where a wall or curb must be cleared the seat should be
installed in a higher position. In its highest position the seat
will clear a 30 inch [762mm] high wall.
5/16" NYLOCK
NUT
5/16" FLAT
WASHER
Copyright © 2016 Aqua Creek Products All Rights Reserved
Revolution Assembly Instructions
CONTROL
ARM
3/8"
FLAT
NYLOCK
WASHER
*STANDARD SEAT-ARM
(OR SPA SEAT-ARM,
OR SLING SEAT-ARM)
*NOTE: FOR APPLICATIONS WHICH USE
MULTIPLE SEAT-ARMS, REMOVE NUTS &
BOLTS AND REPLACE ARM AS REQUIRED.
STEP 5
3/8" X 2"
SHOULDER BOLT
5/16" X 4-3/4"
HEX BOLT
5/16" FLAT
WASHER
STEP 4: INSTALL SEAT ARM
Locate the SEAT ARM and the following hardware:
STEP 4
• (2) 1/2" x 3" SHOULDER BOLT
• (2) 3/8" FLAT WASHER
• (2) 3/8" NYLOCK NUT
Install the SEAT ARM at the ends of the CONTROL
ARM and LIFTING ARM as shown in the figure to the
3/8"
left. Tighten the NYLOCK NUTS until snug as shown in
NUT
PHOTO 4. DO NOT OVERTIGHTEN!
(NOTE: MAKE SURE THE SEAT IS FACING AWAY FROM
THE MAIN ASSEMBLY)
NOTE: FOR APPLICATIONS THAT UTILIZE MULTIPLE
SEAT ARMS (SUCH AS FOR A SLING SEAT OR THE SPA
SEAT-ARM) USE THIS STEP TO REMOVE AND REPLACE
THE SEAT ARM.
SEAT-ARM
HOLES AT 4"
INTERVALS
ALLOW FOR
ADJUSTMENT
OVER 16"
SEAT ASSEMBLY
ADJUSTED TO
LOWEST POSITION
(SEAT WILL ARRIVE
AT HIGHEST
POSITION)
RANGE
Revised 8/11/16
MAIN
ASSEMBLY
7