Avlite AV-70 Manual - Página 10

Procurar online ou descarregar pdf Manual para GPS Avlite AV-70. Avlite AV-70 16 páginas. Aviation light
Também para Avlite AV-70: Manual de início rápido (2 páginas)

Imprimir página

The AV70 light (Ref 1) is attached to the rubber tile (Ref 2) using bolts (Ref 3).

e. Insert bolts through the three centremost holes in the tile, entering from the bottom face (within the

triangular recess). It may be necessary to use a rubber mallet to insert the bolts.

Fit the AV70 light over the bolts on the top face of the tile. (It is possible to align the lens ridge with

the sides of the tile, but this is not a requirement).

g. Install a penny washer (Ref 4) and a wing nut (Ref 5) on each bolt. Tighten wing nuts to finger-

tightness.

3.1.3.2 Installing the light assembly

The completed AV70 – rubber tile assembly is to be mounted on a surface capable of supporting 6kg

minimum. Securing the rubber tile to the mounting surface is optional, however, Avlite recommend that the

tile be secured at a minimum of two points.

a. Place the completed light assembly in the desired location.

b. Using a hammer, drive steel pegs (Ref 6) through the holes in the corners of the rubber tile being

careful not to damage the AV70 light.

Note:- Other means of securing the tile may be used where the mounting surface is not suited to the use of

steel pegs.

Latest products and information available at

NOTE: Charging Battery

New lights should be left in the sun for

several days to ensure battery is

charged before placing in service. The

light will charge whilst turned off.

AV70 Solar Airfield Light