DeZurik G-SERIES Manual - Página 11

Procurar online ou descarregar pdf Manual para Controlador DeZurik G-SERIES. DeZurik G-SERIES 17 páginas. Lift, turn and reseat used on ptw & pfw tapered plug valves
Também para DeZurik G-SERIES: Instrução (7 páginas), Manual (8 páginas), Manual (17 páginas), Manual (14 páginas), Manual (12 páginas), Manual (14 páginas), Manual (16 páginas), Instrução (19 páginas), Manual de instruções (13 páginas), Manual (9 páginas)

Imprimir página

Actuator Disassembly and Assembly

Under normal operating conditions the G-Series actuator does not require routine maintenance. If the

actuator has excessive wear or has been damaged, it is recommended that the actuator be replaced,

not repaired.

Use the following procedure for replacing leaking seals and o-rings. Refer to Figure 2 for component

identification.

Actuator Disassembly

Flow in the pipeline with the actuator removed can slam the valve closed causing

personal injury and damaging the flow system. Shut down the flow in the pipeline

before removing the actuator from the valve.

1. Discontinue flow and relieve pipeline pressure.

When Eccentric Plug valves are mounted in a vertical pipeline, or mounted in a

horizontal pipeline with the plug stem horizontal, there is a chance that gravity will

cause the plug to swing to a lower position in the valve body when the actuator is

removed.

To avoid this hazard, rotate the plug to the lowest position before removing the

actuator.

2. Close the valve or rotate the plug to the lowest position in the valve body.

Remove the actuator from the valve as described in the REMOVING ACTUATOR FROM

VALVE Section of this Instruction.

4. Above Ground Service (GS_A) actuator only - Note the position of the pointer (B1Q), then

remove the screws (B1R) and pointer.

Buried Service (GB_A) actuator only - Remove screws (B13) and cover (B12).

5. Remove the screws (B1M) and cover (B1B).

6. Remove the o-ring (B1N) thru the top of the cover (B1B).

7. Note the position of the gear (B1C) in the housing (B1A), then slide the gear (B1C) out of the

housing.

Remove the two pipe plugs (B1I) from the housing (B1A).

9. Rotate the drive shaft (B1F) until the pins (B1K) line up with the pipe plug holes in the housing

(B1A).

August 2012

Page 11

DeZURIK

D10456