CPcam CPD505ZHD Manual de início rápido - Página 4

Procurar online ou descarregar pdf Manual de início rápido para DVR CPcam CPD505ZHD. CPcam CPD505ZHD 8 páginas.

2) LOOP / INPUT (1 ~ 16CH / 1 ~ 8CH)

LOOP: Video output connector.

INPUT: Connect to video sources, such as cameras.

Note: If you want to make a video backup with audio, please make sure whether your DVR supports the

audio function, and connect audio cameras to the channels which support the audio function.

3) MONITOR

Connect to MAIN monitor for video output.

4) CALL

Connect to CALL monitor to show the channel display one by one.

When any alarm is triggered, CALL monitor will show the image of the triggered channel for a period of time.

5) Audio IN

Connect to audio sources, such as cameras equipped with the audio function.

Please get to know whether your DVR supports the audio function, and how many audio inputs are supported

first.

Note: This DVR series supports four audio-in channels, which are Audio 1, Audio 2, Audio 3 and Audio 4

accordingly, and the audio data will be recorded with the video data of CH1, CH2, CH3 and CH4

respectively.

6) Audio OUT

Connect to an audio device, such as a microphone or speaker.

7) IR

Connect the IR receiver for remote control.

8) EXTERNAL I/O

Insert the supplied 25PIN DSUB to this port for connecting external devices (external alarm, PTZ camera, etc).

For detailed I/O port PIN configuration, please refer to the user manual.

9) RS-485

Connect to external devices (such as a speed dome camera) with RS485-A and RS485-B wires.

10) VGA

Connect to a LCD monitor directly.

11) LAN

Connect to Internet by LAN cable.

12) LINK ACT.

When your DVR is connected to the Internet, this LED will be on.

13) DC 19V

Connect to the supplied adapter.

3. CONNECTION AND SETUP

The HDD must be installed before the DVR is turned on.

Step 1: Loose the screws on the upper cover and open the upper cover of the DVR.

Step 2: With the rear panel facing you, there are three HDD brackets.

2-1: To install the HDD to the right bracket, slide the HDD with the PCB side facing up to the bracket, and

fix it to the bracket with two screws for each side.

2-2: To install the HDD to the left or middle bracket, remove the bracket, and slide the HDD with the PCB

side facing up to the bracket. Fix the HDD to the bracket with two screws for each side.