CPcam CPD505ZHD Manual de início rápido - Página 5

Procurar online ou descarregar pdf Manual de início rápido para DVR CPcam CPD505ZHD. CPcam CPD505ZHD 8 páginas.

Step 3: Connect the power connector and data bus connector to the HDD(s) connected.

Step 4: For HDD installation to the left or middle bracket, replace the HDD bracket back to the DVR base.

For HDD installation to the right bracket, skip this step.

Step 5: Close the upper cover of the DVR, and fasten all the screws you loosened in Step 1.

3.2. Camera Connection

The cameras must be connected and power-supplied BEFORE the DVR is turned on. The DVR will automatically

detect the video system of the connected camera(s) (NTSC / PAL), and switch itself to the correct system.

Connect the camera with the indicated power supply, and connect the camera video output to the DVR video input

port with a coaxial cable or RCA lines with BNC connectors.

Note: For detailed DVR video input / output ports, please refer to "2.2. Rear Panel" at page 3.

For detailed camera operation, please refer to its own manual.

If you want to make a video backup with audio, please connect audio cameras

to the channels which support the audio function. The audio channels are CH1, CH2,

CH3 and CH4.

For speed dome cameras, make sure the RS485 control cable is connected

correctly to the RS485 port on the DVR rear panel. For details, please refer to your

speed dome camera user manual. Then, make sure the camera title, ID, protocol &

baud rate are properly configured. For details, please refer to "5.5 REMOTE" in DVR

user manual.

This device should be operated only with the type of power source indicated on the manufacturer's label. Connect

the indicated AC power cord to the power adapter, and plug into an electrical outlet. The power LED will be on.

Note: To ensure that your DVR works constantly and properly, it's recommended to use an UPS,

Uninterruptible Power Supply, for continuously operation. (Optional)

Before operating your DVR, please set the date and time on your DVR first.

Press "MENU" and enter the password to go to the menu list. The default admin password is 0000. Move to "

and you can set the date / time / daylight saving in the "DATE" menu list.

Note: Please DO NOT change the date or time of your DVR after the recording function is activated.

Otherwise, the recorded data will be disordered and you will not be able to find the recorded file to

backup by time search. If users change the date or time accidentally when the recording function

is activated, it's recommended to clear all HDD data, and start recording again.

Note: For the first time to use the DVR, please charge the DVR for at least 48 hours continuously after the

date & time is set correctly.

Press "MENU" and enter the password to go to the menu list. Then, Move to "ADVANCE" to enter the advanced

setting menu.

In the "ADVANCE" menu, move to "

the password (four digits). The default admin password is 0000.

". Select "PASSWORD" and press "ENTER" to enter the submenu to set

Example of RS485 port on the

DVR rear panel.