CPI CXB2 Manual de instalação - Página 7

Procurar online ou descarregar pdf Manual de instalação para Validador de notas de banco CPI CXB2. CPI CXB2 13 páginas.

SERVICE BUTTON FUNCTIONS

BELT CLEANING MODE:

To start the belts; press Service Button twice (press/pause time is less than 1 sec.).

• Use a clean damp cloth. Gently press it against the moving belt to clean.

• To stop cleaning, press Service Button once; otherwise the belt motion will stop in 20 seconds

automatically.

DISPLAY QUANTITY OF UNCREDITED BILLS IN A NOTE CASSETTE:

• To check the quantity of accepted, BUT un-credited bills in a Note Cassette, press and hold the

Service Button for more than 3 seconds in Idling or Disable state.

• Count the number of short Blue flashes of the Diagnostic LED. This indicates the number of notes

that are in the cassette for which no credit was issued.

• This counter will be cleared if the Note Cassette is removed or the power is turned off.

SET BRIGHTNESS OF BEZEL BLUE RUNNING LIGHTS:

• Turn OFF power to the validator.

• Switch the unit to Service Mode (SW 8 is ON) and reapply power.

• Press the Service Button once (less than 1 sec.) to switch between two levels of brightness of the

bezel blue running lights.

• Switch power off when desired brightness is set, then switch the unit to Working Mode (SW 8 is

OFF) and reapply power.

CLEANING:

The CXB2 series will not need cleaning as often as magnetic sensing Note Validators. If

cleaning is required, use compressed air and a soft cloth moistened with mild, non-abrasive

detergent.

Refer to Repair Manual for more cleaning instructions.

• Locate the service button on the top of the unit (refer to Figure 5). Depress the button

twice to enter belt cleaning mode.

• The belts will run for 20 seconds.

• Press a damp, soft, cloth moistened with mild, non-abrasive detergent against the belts to

clean.

CPI 2016

See Figure 6.

Figure 5

P/N# 253052002

Belts

CXB2

Mexico

Figure 6

http://www.cranepi.com