CPI Talos T700 Manual de instalação - Página 3

Procurar online ou descarregar pdf Manual de instalação para Validador de notas de banco CPI Talos T700. CPI Talos T700 4 páginas.

Imprimir página

Configuration Coupons - Continued

Insert the configuration coupon and verify the settings were accepted by counting the bezel flashes

Bezel LED Error Flash Codes

When the unit is ready and enabled, the bezel LEDs will flash continuously. If the bezel LEDs are off, the unit has an error. To determine the error, partially insert

and hold a bill in the bill path until the bezel lights flash. Count the flashes and refer to the chart below.

Talos Install Guide_Web_5.24.19.indd 3

Flashes

Meaning

Configuration coupon accepted and unit

successfully programmed.

Coupon rejected. Number of flashes corresponds

1 - 5

to the coupon section that was improperly filled

out. Try again.

Coupon not read. Confirm the coupon is

correct and try again.

Flashes

Problem

None

No power

1 or 4

Bill path

blocked

Another

vending

component

Lower

housing

assembly

Bill magazine

removed

Continuous

Stacker full

fast

Continuous

Unit is

slow

defective

Solution

Restore power to validator or machine

Check for jams. Remove bill

magazine and lower housing

assembly and inspect

Ensure the unit has been enabled,

then check:

• Vending Machine Controller

• Coin manager and coin levels

• Inventory levels

• The door is locked properly

Check that the lower housing

assembly is seated. Ensure bill path

is clean; see Cleaning section

Reattach bill magazine

Empty the bill magazine

Replace the unit

5/24/2019 9:57:14 AM