Dell PowerEdge 2800 Conversão Manualline - Página 16
Procurar online ou descarregar pdf Conversão Manualline para Servidor Dell PowerEdge 2800. Dell PowerEdge 2800 36 páginas. Poweredge 2800 server
Também para Dell PowerEdge 2800: Atualização da informação (24 páginas), Manual de instalação (22 páginas), Manual (44 páginas), Instalação de hardware (14 páginas), Referência rápida (2 páginas), Especificações (2 páginas)
Imprimir página
Y1001bk0.book Page 14 Thursday, July 8, 2004 4:32 PM
Figure 1-6. Removing/Installing the Control Panel Assembly and Front Panel
screws (3)
T-10 Torx
screws (22)
Using a T-10 Torx driver, remove the 22 screws that secure the tower front panel to the drive
tray. See Figure 1-6.
Installing the Rack Front Panel and Control Panel Assembly
Install the rack front panel
Orient the system as shown in Figure 1-6.
a
Using a T-10 Torx driver, install the 22 screws (that came in your kit) that secure the rack
b
front panel to the drive tray.
NOTE:
rack systems. Only the carrier is different. When converting your tower system to a rack system, you must
remove the LCD board and the I/O board from the control panel assembly that you removed in step 2 of
"Removing the Control Panel Assembly and Tower Front Panel."
14
Tower-to-Rack and Rack-to-Tower Conversion Guide
control panel
cable clamp
The control panel assembly's LCD board and the I/O board are the same for both the tower and
drive tray in
maintenance
position
front panel
control panel
assembly