3 Day Blinds 2 Começar a trabalhar - Página 6

Procurar online ou descarregar pdf Começar a trabalhar para Estores de janela 3 Day Blinds 2. 3 Day Blinds 2 8 páginas.

TILT WAND ATTACHMENT
(Not applicable for blinds ordered with a cord tilt)
6
| 2 & 2
/
" Wood & Faux Wood & Angled Slat Blinds
1
2
• At the top of the tilt wand
(provided separately),
you will find a plastic
sleeve that covers a metal
hook.
• Remove the plastic sleeve
on the tilt wand by pulling
gently upward.
• Make sure the metal hook
attached to the tilt wand
is in the open position.
• On one end of the
headrail, you will find a
small metal shaft with a
hole protruding from the
headrail.
• Take the plastic sleeve
you just removed from
the tilt wand and slide
it up and over the shaft
protruding from the
headrail so that the hole
at the end of the shaft is
exposed.
• Insert the metal hook into
the hole in the shaft.
• Slide the plastic sleeve
down the shaft and over
the tilt wand hook until it
is secure.

BLIND OPERATION

CORDED
• To tilt the slats, twist the tilt wand. If you ordered a cord
tilt, YOU MUST take one cord in each hand applying slight
tension to each cord, and pull gently down to tilt the slats to
the desired angle.
• Do not attempt to raise or lower the blind unless the slats
are in a completely open (horizontal) position.
• To raise the blind, pull the lift cords down.
• To engage the lock, pull the lift cords down and toward the
outside of the blind.
• To lower the blind, pull the lift cords down and toward
the center of the blind and allow the cords to slide slowly
through your hand.
NOTE: Light-less® Blinds are manufactured without ladder
holes in each slat to allow for tighter closure and superior
light control. As such, slats may become dislodged from the
support ladders during shipping. If this occurs, the slats are
easy to reposition. The notch on the slat is to be placed at the
rear of the blind.
ULTRALIFT CORDLESS™
• To tilt the slats, twist the tilt wand.
• Do not attempt to raise or lower the blind unless the slats
are in a completely open (horizontal) position.
• To raise and lower the blind, press the button on the
bottomrail while simultaneously moving the blind up or
down into the desired position.
Note: The button must be engaged to raise or lower the
blind. Releasing the button will lock the blind into place.