Dell PowerVault TL2000 Instruções de anexação - Página 11

Procurar online ou descarregar pdf Instruções de anexação para Armazenamento Dell PowerVault TL2000. Dell PowerVault TL2000 17 páginas. Tape library
Também para Dell PowerVault TL2000: Notas de lançamento (3 páginas), Começar a trabalhar (38 páginas), Perguntas frequentes (26 páginas), Manual de início rápido (7 páginas), Manual do software (16 páginas), Manual de configuração (22 páginas), Manual de informações importantes (10 páginas), Adenda ao Manual do Utilizador (2 páginas), Manual de iniciação (3 páginas), Brochura (4 páginas), Manual do utilizador (20 páginas)

iSCSI for TL-Series Tape Libraries

SEPTEMBER 2008

Note: If Jumbo Frames are enabled, they must be enabled for all devices across the network

(including the host, target, and any switches or routers in between). Jumbo frame sizes will

allow for greater packet payloads and lower overhead traffic, resulting in likely performance

increases.

Note: If the ICMP "PING" command will be used to network connectivity, the "Enable ICMP

PING responses" checkbox must be checked.

After these settings have been enabled, the Windows iSCSI initiator on the host computer can

be used to perform discovery of the MD3000i target. After the iSCSI initiator on the host has

discovered the MD3000i, go to the "Configure" tab on the MDSM and select "Configure Host

Access - Manual". Enter the host name into the configuration, select the operating system,

and select "Next". This will guide the user to a screen to select iSCSI initiators. If a known

initiator is displayed, highlight it, click "Add", and then "Next". Otherwise, select "New" and

enter the iSCSI initiator name and select "Next". After selecting whether the host is on a Micro-

soft cluster, click "Finish".

If CHAP is going to be used in the iSCSI network, it can be enabled at this point under the

"iSCSI" tab under the "Change Target Authentication" and "Enter Manual Authentication Per-

missions" selections in MDSM.

SECTION 7

BACKUP EXEC 12 FOR WINDOWS SERVER INSTALLATION

Symantec offers a good backup solution for SAN based environments and can easily be con-

figured for iSCSI. Symantec recommends that you have connected all of the I/O controllers,

tape hardware devices, and other storage devices to the system where Backup Exec will be

installed before beginning the Backup Exec installation. Before installing Backup Exec 12 for