Dell Force10 S4810 Manual de implantação - Página 23
Procurar online ou descarregar pdf Manual de implantação para Interruptor Dell Force10 S4810. Dell Force10 S4810 36 páginas. Dell force10 s4810 switch
Também para Dell Force10 S4810: Manual de início rápido (27 páginas), Manual de configuração (17 páginas), Manual de configuração (17 páginas)
Imprimir página
OpenFlow Instances
This section describes how you can use OpenFlow instances on a switch.
•
You can use up to eight OpenFlow instances on a switch; the OF ID range is 1–8.
•
Only Transmission Control Protocol (TCP) connections are supported on Dell Force10 switches. Transport Layer
Security (TLS) connections are not supported.
•
Currently, you can configure only one controller IP and one TCP port for each OF instance.
•
The connection is established when you enable the OF instance using the no shut command.
NOTE: You cannot modify the OF instance while it is enabled. To make configuration changes, you must
use the shut command on the OF instance, as shown below.
FTOS#show running-config openflow of-instance
!
openflow of-instance 1
controller 1 10.11.205.184
shutdown
FTOS#
•
The show openflow of-instance command displays details on the instance, as shown below:
FTOS#show openflow of-instance 1
Instance
: 1
Admin State
: Down
Interface Type
: Port
DP Id
: 00:01:00:01:e8:8b:1a:30
Forwarding Tbls : acl
Flow map
:
LB assist
: disabled
EchoReq interval: 15 seconds
Connect interval: 15 seconds
Number of Flows : 0
Packets (acl)
: -
Bytes (acl)
: -
Controller 1
: TCP, 10.11.205.184/6633, not-connected
Controller 2
: -
Port List
:
Vlan List
:
Vlan Mbr list
:
tcp
7
23