Dell Force10 S4810 Manual de implantação - Página 25

Procurar online ou descarregar pdf Manual de implantação para Interruptor Dell Force10 S4810. Dell Force10 S4810 36 páginas. Dell force10 s4810 switch
Também para Dell Force10 S4810: Manual de início rápido (27 páginas), Manual de configuração (17 páginas), Manual de configuração (17 páginas)

Dell Force10 S4810 Manual de implantação

OpenFlow Interfaces

This section describes how you can apply OpenFlow to specific interfaces.
You can use the S4810 and Z9000 as Hybrid switches, allowing both OpenFlow (OF) and legacy functionality
simultaneously.
By default, all ports are available for legacy functionality.
To enable OpenFlow, associate a port or VLAN to an OF instance. You can only do this when the OF instance is
disabled (in a "shut" state).
OpenFlow is supported with link aggregation groups (LAGs); for example, you can configure port channel
interfaces as OF ports or as members of OF VLANs.

OF Ports

The following configuration example associates two ports (Te 0/7 and Te 0/31) to of-instance 1:
FTOS(conf)#interface tengigabitethernet 0/7
FTOS(conf-if-te-0/7)#of-instance 1
FTOS(conf-if-te-0/7)#interface tengigabitethernet 0/31
FTOS(conf-if-te-0/31)#of-instance 1
FTOS(conf-if-te-0/31)#
To see the list of ports associated with an OF instance, use the show openflow of-instance command. The
number displayed in parentheses is the port ID sent to the controller (for example., Te 0/7 is sent to the controller as of-
port 8, as shown below).
FTOS#show openflow of-instance 1
Instance
: 1
Admin State
: Up
Interface Type
: Port
DP Id
: 00:01:00:01:e8:8b:1a:30
Forwarding Tbls
: acl
Flow map
:
LB assist
: disabled
EchoReq interval
: 15 seconds
Connect interval
: 15 seconds
Number of Flows
: 1 (acl:1)
Packets (acl)
: 0
Bytes (acl)
: 0
Controller 1
: TCP, 10.11.205.184/6633, connected (equal)
Controller 2
: -
Port List
:
Te 0/7 (8), Te 0/31 (32)
Vlan List
:
Vlan Mbr list
:

OF VLANs

Instead of assigning an entire port to an OF instance, you can assign a VLAN to an OF instance. You must do this when
the VLAN is created. You must enter OF VLAN members in the same way as a legacy VLAN.
8
25