EarthQuake Cinenova Grande Manual do utilizador - Página 11
Procurar online ou descarregar pdf Manual do utilizador para Amplificador EarthQuake Cinenova Grande. EarthQuake Cinenova Grande 16 páginas. 5/7 channel power amplifier
Imprimir página
Cinénova Grande Power Amplifiers
Technology and Materials
EZXS Detachable Monaural Blocks:
Five or seven totally independent mono-block amplifiers each with its
own power supply circuitry and pre-amplification stage for high fidelity
audio reproduction. For ease of service, each block can be individually
removed and serviced without the need to ship the entire amplifier.
EZXS® is a trademark of Earthquake Sound Corporation.
Multiple Heat Sinks:
Over 500 square inches of heat radiating aluminum surface
channel maximizes heat exchange for cooler amplifier operation. The
12 gauge steel cover is perforated - top, sides & bottom- for effective air
circulation.
Peak LED Indicators:
These LEDs monitor the corresponding channel's output level. The
LEDs will come on only when the amplifier output reaches its maximum
level, near 1% THD. If an LED flickers that is ok. If an LED should remain
on for longer than 10 seconds then simply back the volume down
slightly to maintain a stable level of output.
Thermal Protection:
Each monaural block is equipped with a thermal sensor designed to
shut the amplifier down when it overheats. Overheating is not typical.
It only occurs if the amplifier is over driven with low impedance
speakers, or if the amplifier is located in an improperly ventilated
space.
The Thermal Protection Circuit will kick in at 85ºC and
release at 65ºC. It is unusual for this amp to reach temperatures of
this nature during normal or high power operation.
Individually Selected and Matched Components:
Components used to construct the Cinénova Grande are subjected
to an exhaustive selection process; during which, the components
are matched and individually tested to exact tolerances. Which leads to
the impressively low idling current of 600mA for 5ch the Cinénova.
Toroid Power Transformer:
Each Cinénova contains a monstrous 4KVA high efficiency bifilar toroid
transformer. This ferrite core transformer weighs over 30Lbs and is
wound with oxygen free, 99% pure copper that minimizes transport
losses. Hum suppression is accomplished by using a 12 gauge toroid
mount, insulated with 10 layers of pressed foam.
Special Features
Independent amplification blocks & power supplies
®
(EZXS detachable monaural blocks)
Built-in line conditioner
5-channel and 7-channel configurations
Soft Start Circuitry
Fully balanced inputs
per
12VDC trigger input
Three-way mode selection switch: High-pass, By-pass &
Low-pass
20Hz-5kHz variable crossover for each channel
Oversized bifilar toroidal power transformer with
extraordinarily low DC resistance and thermal protection
Fuse Fault Indicators
Thermal protection against overheating
Individually selected and matched components
Speaker protection against DC and frequencies below 10Hz
Protection against short circuits, device failures, miss wiring,
and internal faults
Heavy duty gold plated output terminals
Front mounted removable handles
Note:
The soft start circuitry will cause a slight delay (around 6 seconds)
between the time when the amplifier is switched on and the time when
you hear any audio through the speakers. This time delay is essential as
it slows down the rushing current at initial start up, allowing it to slowly
charge the huge capacitor banks that power up the amplifier
Special Features
11