Allo.com CT200E Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Placa PCI Allo.com CT200E. Allo.com CT200E 12 páginas. Transcoding card
Imprimir páginaTranscoding Card CT200E - User Manual
To install your CT200E card, you will need:
Full Linux kernel 2.6.15 (or later) source code.
Development libraries and headers for ncurses
Development libraries and headers for zlib and openssl
Development libraries and headers for newt
GCC and standard software build tools
Bridge tools (brctl)
Installation Test Environment considered
OS
Kernel version
Asterisk version
Hardware
Library
1. After inserting the card into your PCIe slot, boot your machine to Linux and
execute the following command to list the devices detected by the PCI
bus:
# lspci
Confirm the output lists a device with Allo.com's PCI vendor ID which is
"
". The output will be similar to the following:
BCM57761
02:00.0 Ethernet controller: Broadcom Corporation NetXtreme
BCM57761 Gigabit Ethernet PCIe (rev 10)
Note: The output of lspci may or may not state "Allo.com". If it does not,
this does not indicate a problem.
The Allo.com card identifier should be listed. If a card identifier is not listed,
then your machine is not PCI 2.2 (or higher), and the card will not work.
2. To install asterisk in CentOS, we have to install the following prerequisite
packages:
• bison
• bison-devel
• zlib
• zlib-devel
• openssl
• openssl-devel
• gnutls-devel
• flex
• gcc
• gcc-c++
Execute the following command to install the above mentioned packages:
# yum install bison bison-devel zlib zlib-devel openssl
openssl-devel gnutls-devel flex gcc gcc-c++
Version: 1.0
:
CentOS 5.5 (32 or 64 bit)
:
2.6.18-194.el5
:
Asterisk 1.4.43
:
ALLO Transcoding card
:
allotc libraries
Page 5