Allo.com CT200E Manual do utilizador - Página 8
Procurar online ou descarregar pdf Manual do utilizador para Placa PCI Allo.com CT200E. Allo.com CT200E 12 páginas. Transcoding card
Imprimir páginaTranscoding Card CT200E - User Manual
9. Setup the IP address for DSP in the transcoding module only the last
octet
E.g.: Specify last octet of the IP addres: [1-255] or <enter> for default:
10. Configure the port range with given interval
E.g.: Specify udp base value [9000-65000] or <enter> for default:
Configuration
This chapter provides a step by step instruction to configure the CT200E
transcoding card.
Configuring the System for Transcoding
1. Finally change the RTP IP address in the file allo_codec.conf available
in the prompted path (For Eg:/etc/asterisk) and change the "rtpip=<your
machine ip>"
2. Configure SIP extensions by allowing all the codecs "allow=all"
Status of card
1. Make sure the transcoding sessions are configured properly in the
asterisk CLI prompt,
Localhost CLI> allo show translators
You should see the codec translators configured
Version: 1.0
Page 7