Miller Spoolmate 3035 Manual do Proprietário - Página 18
Procurar online ou descarregar pdf Manual do Proprietário para Sistema de soldadura Miller Spoolmate 3035. Miller Spoolmate 3035 28 páginas. Wire feeder spool gun
Também para Miller Spoolmate 3035: Manual do Proprietário (36 páginas), Manual do Proprietário (28 páginas)
Imprimir página
3-5. Installing Wire Spool And Threading Welding Wire
Tools Needed:
5
9
10
Press gun trigger to feed wire to check drive roll
pressure. Turn screw enough to prevent slipping.
OM-1216 Page 14
6 7
8
3
Remove nozzle and contact tip. Push
and hold red lever. Thread wire through
inlet guide, past push roll/drive roll, and
out end of gun 2 inches (50 mm).
Install contact tip and nozzle. Reinstall
spool cover and thumb screw.
.
Screw rotation clockwise decreases
drive roll pressure and counterclockwise
rotation increases pressure.
Wood
1
Thumb Screw
2
Spool Cover
Remove thumb screw and spool
cover.
3
Hub Tension Nut
4
Wire Spool
Install spool so wire feeds from top.
4
Turn hub tension nut just so a slight
drag is felt on the wire spool.
2
5
Push Roll/Lower Drive Roll
6
Drive Roll Pressure
Adjustment Opening
1
7
Drive Roll Release Lever
(Red)
8
Wire Inlet Guide
9
Contact Tip
10 Nozzle
Release red lever.
Turn On welding
power source power.
Cut off wire.
Ref. 801 891-B