Miller XR-ALUMAFEED Manual do Proprietário - Página 32
Procurar online ou descarregar pdf Manual do Proprietário para Sistema de soldadura Miller XR-ALUMAFEED. Miller XR-ALUMAFEED 44 páginas.
SECTION 8 − MAINTENANCE & TROUBLESHOOTING
8-1. Feeder Drive Assembly Maintenance
5
6
Tools Needed:
5/16 in
OM-239 210 Page 28
!
Replace
Damaged Or
Unreadable
Labels
Blow Out Or
Vacuum Inside
8
Disconnect power
before maintaining.
3 Months
Clean
And
Tighten
Weld
Terminals
6 Months
1
7
2
3
4
.
Maintain more often
during severe conditions.
Replace Damaged
Gas Hose
Repair Or Replace
Cracked Cables
And Cords
Clean
Drive
Rolls
Retract wire onto spool.
1
Pressure Roll Assembly
2
Drive Motor Shaft
3
Drive Roll
4
Screw
Use wire brush to clean drive roll.
5
Drive Roll Idler
6
Shoulder Washers
Use wire brush to clean idler.
7
Outlet Guide
8
Wire Inlet Guide
Pull guide toward rear of feeder to
remove. Install new guide.
Thread welding wire and adjust
drive roll pressure, if necessary
(see Section 5-8).
Drive roll and idler are available for
the following wire size ranges:
.035 wire size
.040 wire size
.047 wire size
.062 wire size
When changing wire size, change
control box drive roll and idler, gun
pressure roll and drive roll.
805 350-A