AQUAPHOR OSMO PRO 50 EU Manual - Página 9

Procurar online ou descarregar pdf Manual para Sistemas de filtragem de água AQUAPHOR OSMO PRO 50 EU. AQUAPHOR OSMO PRO 50 EU 16 páginas.

Imprimir página

Preparation for work

Flushing OSMO PRO

At the last stage of the preparation of premium

drinking water in OSMO Pro, a natural mineral

is used, which enriches the purified water with

useful substances. Since this mineral is quite frag-

ile, dust may form during transportation, which

must be washed off the first time you start the

water purifier.

...........................................................................................

NOTE: It will take about 5 hours to fully flush the

water purifier (cartridges and tank). The duration

of the flush depends on the pressure, water tem-

perature and membrane performance.

ATTENTION! Make sure the cartridges are posi-

tioned correctly before flushing. The positioning

of the cartridges in the water purifier is indicated

on the Water purifier installation diagram. Make

sure the flush plug is installed in the middle slot.

...........................................................................................

• Close the tap (20) on the storage tank (the

tap flag must be turned perpendicular to the

outlet tube).

• Open the inlet tap on the connection unit (23)

and clean water tap (7).

• Drain the water passing through the OSMO Pro

within 10 minutes.

• Close the inlet and clean water tap.

• Install a membrane cartridge in the middle slot

of the housing instead of the flush plug.

• Open the inlet tap on the connection unit, the

storage tank tap and the clean water tap.

• Drain the OSMO Pro for 1 hour.

• Close the clean water tap.

• Make sure the OSMO Pro connections are tight.

Flushing the storage tank

The procedure for filling the tank twice will take

no longer than 3 hours.

• Close the tap (20) on the storage tank (the

tap flag must be turned perpendicular to the

outgoing tube) and open the inlet tap on the

connection unit (23).

• Open the clean water tap (7). After the water

starts dripping from the tap of clean water, close

it and open the tap of the storage tank – the

tank will begin to fill.

• Make sure there are no leaks; tighten the con-

nections if necessary.

• After filling the storage tank (when water stops

flowing from the drain tube (16), open the clean

water tap and wait until all the water flows out

of the storage tank (water will start to flow out

of the tap very slowly; this is not a malfunction

of the water purifier).

• Re-fill and drain the water storage tank.

• Make sure the OSMO Pro connections are tight.

• After filling the tank for the third time, the OSMO

Pro is ready for use.

...........................................................................................

ATTENTION! The water that was obtained from

the first and second filling of the tank is not

drinkable.

ATTENTION! Check the OSMO Pro daily for leaks

during the first week of use.

NOTES. During the first week of OSMO Pro oper-

ation, when switching the automatic valve, there

may be noise associated with the release of air

from the internal cavities of the water purifier.

This is not a malfunction.

...........................................................................................

During initial operation of OSMO Pro, the color of

the water can be milky due to small air bubbles

being forced out of the system.

10 minutes

1 hour