AQUAPHOR RO-70S Manual do Proprietário - Página 5

Procurar online ou descarregar pdf Manual do Proprietário para Sistemas de filtragem de água AQUAPHOR RO-70S. AQUAPHOR RO-70S 13 páginas. Drinking water machine

Imprimir página

• At an effort of 8–10 kgf, the tube should not be able to be pulled out.

• Set the input valve to the position Closed.

• Open the water from the main line.

Important! Make sure that the sealing pad was on its own place

and was not damaged during installation of the connection node.

Installation of the faucet for clean water* (fig. 4)

• Drill a 12 mm hole in the sink (countertop).

• Put the decorative stand (2), the rubber gasket (3), the rubber washer

(4) on the threaded shank (1) of the faucet and insert the tap into the

wash hole.

• Place the plastic washer (5), the metal lock washer (6) on the threaded

shank from the bottom of the countertop and screw the fastening nut

(7).

• Insert the tube (9) into the threaded shank of the tap (1) with the end

of the pressed metal sleeve and tighten the union nut (8) until it

stops;

• Check the strength of the tube (9). The tube should not be able to be

pulled out when using a force of 8–10 kgf.

Attention! We recommend that you use the clean water faucet

included with this product. The use of other faucets can lead to vibrations and other extraneous

sounds.

Drain saddle installation (fig. 5)

• It is the best install the drain saddle on the sink

drain before the siphon trap or bend (the drain

saddle on most drain pipes is of ~40 mm diameter).

• Remove the protective film (2) from the gasket (1).

Glue (or fasten) the sealing gasket (1) from the

inside of the clamp so that the hole in the gasket

matches the hole in the saddle union.

• Install the saddle on the drain line and then tighten

the bolts (3). Bolts should be tightened evenly, so

that the two parts of the yoke are parallel.

• Drill a hole 7 mm in diameter through the hose

connection.

• On the JG drain tube, put on the plastic nut and,

inserting the tube into the drainage collar, screw the nut onto the nipple.

Installing the crevice insert** (fig. 6)

• Remove the crevice insert, which is under the cover of the water

purifier. In order to remove the cover, it is necessary to turn the

three latches counter-clockwise.

• Insert the crevice insert into the 3/8" (9.5 mm) tube as shown in

fig. 6 and connect this end of the tube to the water cleaner.

Attention! The kit includes three inserts: one for the

installation, two are spares.

* The manufacturer reserves the right to use the connection points and

faucet of a similar design. If necessary, contact the after-sales service.

** The crevice insert is installed only for the water with a high content of

mechanical impurities in the water.

AQUAPHOR RO-70S | Owner's manual

Figure 4

Figure 5

Crevice

insert

Figure 6