Burley NOMAD RACK Manual de instruções e de segurança do proprietário - Página 7

Procurar online ou descarregar pdf Manual de instruções e de segurança do proprietário para Veículo utilitário Burley NOMAD RACK. Burley NOMAD RACK 18 páginas. Bicycle trailer
Também para Burley NOMAD RACK: Brochura e especificações (5 páginas), Manual do proprietário e manual de segurança (20 páginas), Manual de instruções e de segurança do proprietário (12 páginas), Manual do proprietário e de segurança (4 páginas), Manual de instruções e segurança do proprietário (12 páginas), Manual de instruções e de segurança do proprietário (11 páginas), Manual do proprietário e de segurança (20 páginas)

Flatbed

: Remove the thumb nut from the quick-release

™

lever. Insert the quick-release lever through the hollow

axle of the wheel, making sure the lever is on the flat

side of the wheel and the springs are mounted on each

side as shown in the illustration. With the quick-release

lever in the unlocked position, place the wheel into the

dropouts, making certain that the axle goes all the way

into the slots. Once the wheel is fully seated, replace

and tighten the thumb nut. You should feel resistance

halfway through closing the lever. Position the quick-

release lever so that it is aimed to the rear of the trail-

er in the "CLOSED" position (the lever is marked for

OPEN or CLOSED positions). Repeat for the other wheel.

Note: Wheels are not centered on the axle.

IMPORTANT:

that tires are offset away from side rails, closest to outer frame.

Make sure the wheels are held securely; you should not be able to rock or

shift them. Do not operate with tires inflated above 5 P.S.I. Improperly

installed wheels or over-inflated tires can cause an accident or serious

Installing the Side Rails

Nomad

: Flip the four plastic (C-shaped) side

™

panel hold-downs to the outside. Slide each

side rail down over the side rail guides at the

front and rear of each side of the main frame.

The narrower end of each side panel goes to

the rear, with the "Burley" logo facing outward.

Snap the plastic side panel hold-downs over the

side panel tubing at the front and rear of each

side as shown.

Wheels are dished off-center and must be installed so

WARNING

B U R L E Y T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L

Side

Panel

Hold-down

(snapped

in place)