Aquasana OptimH2O AQ-RO-3 Manual do Proprietário - Página 4
Procurar online ou descarregar pdf Manual do Proprietário para Sistemas de filtragem de água Aquasana OptimH2O AQ-RO-3. Aquasana OptimH2O AQ-RO-3 16 páginas. Whole house water filter
Também para Aquasana OptimH2O AQ-RO-3: Manual do Proprietário (14 páginas), Manual do Proprietário (11 páginas), Manual do Proprietário (10 páginas)
Imprimir página
2
2
INSTALLATION STEPS
Tools recommended for installation:
• Drill
• Wrench
• Channel locks
• PVC pipe cutter
Before installing
• Lay out system in appropriate configuration. Improper sequence of
equipment will affect performance, and could possibly damage your
system.
• For all installations: Anticipate the need for additional parts and pieces including
but not limited to PEX tubing, clamps, and mounting screws to install unit
properly (available at a local home improvement stores or through your plumbing
contractor). Due to the varieties of home design, not all configurations can be
addressed in this guide.
• DO NOT install this filter where the line pressure may exceed 125 psi. The operating
pressure range for this filter is between 25psi – 125psi.
• Install on cold water lines only (32° – 120°F).
• Filter usage must comply with all state and local laws. Aquasana and its
manufacturer are not liable for consequential or incidental damages due to
improper installation.
• DO NOT install the unit on its side. It must be installed upright to maximize contact
with media bed.
Please read all precautions and instructions carefully before using.
Precautions
• Properly tighten all fittings to ensure a leak-free assembly.
• NSF certified Plumber's Tape is the only sealer that can be used on threaded fittings.
DO NOT use pipe dope or PVC primer/glue on threaded fittings. Exposure to these
compounds will damage nipples causing leaks.
• Pick an appropriate installation location. Dimensions of systems vary—always allow
an estimated minimum of 50" clearance for height of tank, and a minimum of 45"
for floor space.
• Unit must be installed in an area where the main water line enters your home,
before connecting to the water heater. DO NOT install after a water heater or on
the hot water line.
• It is recommended your system be installed indoors and out of direct sunlight.
Prolonged exposure to light can weaken plastic components, resulting in filter
housing failure. If this is not possible and the system is outdoors or in a sunny area,
the unit must be protected from both direct sunlight and freezing temperatures.
• If installing on metallic plumbing, two grounding clamps and #4 copper wire are
essential for safety.
• NSF approved PVC primer and glue
• NSF certified Plumber's Tape (thread sealing tape)
• Copper wire & grounding clamps
(if copper pipes are present)