Diamond Audio Technology D5 300.2 Manual do Proprietário - Página 12
Procurar online ou descarregar pdf Manual do Proprietário para Amplificador para automóvel Diamond Audio Technology D5 300.2. Diamond Audio Technology D5 300.2 17 páginas. Professional reference series amplifier
Também para Diamond Audio Technology D5 300.2: Diagrama esquemático (4 páginas)
BASIC TROUBLESHOOTING
1.
Amplifier has no output.
Is LED (located on power/ground endpanel) lit?
Yes: Make sure audio signal is present at RCA inputs. If no signal is
present, use alternate signal source and try again. If signal is
present, check configuration of crossovers. If still no signal, contact
your authorized dealer.
No: Check power, ground and remote wire for +12V. Verify all
connections. If voltages are correct and still no LED, contact your
authorized dealer.
2.
Sound in one channel only.
Reverse left and right RCA cables at amplifier inputs. Is the sound
now in the opposite channel?
Yes: Reverse the input RCA cables in every product installed BEFORE
your amplifier until the problem is found. Check RCA cables for
open connections. Repair as necessary.
No: Check the speaker or speaker wires of the dead channel and
repair as needed. If speaker and wire are OK, contact your
authorized dealer.
3.
The amplifier channels "squeal" when operating.
One or more speaker wires are shorted or one or more speaker
voice coils are shorted or rubbing. If speakers and wires are OK,
contact your authorized dealer.
4.
Amplifier volume cuts out as music is playing without
touching any system controls.
Amplifier is going into thermal protection. Make sure amplifier has
room to breathe. Preventing air from reaching the heatsink will
cause the amplifier to overheat, as will running the amplifier at too
low of an impedance.
Diamond Audio Technology 10