HP ProCurve 1600M Manual de instalação - Página 18

Installing the GL Modules

Verifying the Network Connections Are Working

Check the port LEDs for the newly-installed module to ensure that the port(s)

connected in the preceding step are operating correctly. Each port on the

switch modules has Link and Mode LEDs near it as shown in the next

illustration.

Example Link and Mode LEDs

Link and Mode LEDs

hp procurve

10/100-TX

gl module

J4862B

The Link LED will be lit for each port that is connected properly to an

active network device.

If the Link LED does not go on when an active network cable is connected

to the port, there may be something wrong with the cable, the cable

connectors, or the device at the other end of the cable. See the trouble-

shooting information on page 16.

If the switch Mode is set to display activity (the

is lit), then the Mode LED for each port that is transmitting and/or

receiving packets will flicker when traffic is detected on the port.

If the Mode is set to display full duplex (the

lit), then the Mode LED will be lit for each port that is operating in full

duplex.

If the Mode is set to display maximum link speed operation (the

indicator LED is lit), then the Mode LED will be lit for each port that is

operating at its maximum possible link speed. For gigabit-capable ports,

that speed would be 1000 Mbps (Gigabit); for 10/100 ports, that speed

would be 100 Mbps.

10/100-TX Por ts (1-24)

FDx

Link|Mode

Act

mode indicator LED

mode indicator LED is

Max

mode