HP ProCurve 1600M Manuel d'installation - Page 18

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} HP ProCurve 1600M. HP ProCurve 1600M 36 pages. Redundant power supply
Également pour HP ProCurve 1600M : Fiche technique (12 pages), Lisez-moi d'abord (8 pages), Manuel du réviseur (27 pages), Manuel complémentaire (2 pages), Manuel complémentaire (2 pages), Manuel d'installation (28 pages), Manuel d'installation (28 pages), Manuel d'installation rapide (2 pages), Manuel d'installation rapide (4 pages), Manuel de l'utilisateur (8 pages), Supplément au manuel (28 pages), Lisez-moi d'abord (16 pages), Installation et retrait (2 pages), Manuel d'installation (12 pages), Manuel de planification et de mise en œuvre (40 pages), Instructions de démontage du produit en fin de vie (2 pages), Manuel d'installation (46 pages), Manuel de diagnostic (2 pages), Instructions de démontage (2 pages)

Imprimer la page
HP ProCurve 1600M Manuel d'installation
Installing the GL Modules
12

Verifying the Network Connections Are Working

Check the port LEDs for the newly-installed module to ensure that the port(s)
connected in the preceding step are operating correctly. Each port on the
switch modules has Link and Mode LEDs near it as shown in the next
illustration.
Example Link and Mode LEDs
Link and Mode LEDs
1
2
7
8
1
hp procurve
10/100-TX
gl module
7
J4862B
The Link LED will be lit for each port that is connected properly to an
active network device.
If the Link LED does not go on when an active network cable is connected
to the port, there may be something wrong with the cable, the cable
connectors, or the device at the other end of the cable. See the trouble-
shooting information on page 16.
If the switch Mode is set to display activity (the
is lit), then the Mode LED for each port that is transmitting and/or
receiving packets will flicker when traffic is detected on the port.
If the Mode is set to display full duplex (the
lit), then the Mode LED will be lit for each port that is operating in full
duplex.
If the Mode is set to display maximum link speed operation (the
indicator LED is lit), then the Mode LED will be lit for each port that is
operating at its maximum possible link speed. For gigabit-capable ports,
that speed would be 1000 Mbps (Gigabit); for 10/100 ports, that speed
would be 100 Mbps.
3
4
5
9
10
11
10/100-TX Por ts (1-24)
FDx
6
13
Link|Mode
12
19
Link|Mode
12
19
Act
mode indicator LED
mode indicator LED is
Max
mode