HP ProCurve 1600M Manuel d'installation - Page 20

Replacing or Removing a Module

C a u t i o n

Replacing or Removing a Module

Follow these procedures to replace one module with another, or to remove a

module without replacing it:

Remove any network cables from the ports on the module.

On the module you want to remove from the switch, unscrew the retaining

screws enough to disconnect them from the threaded holes in the switch.

hp procurve

10/100-TX

gl module

J4862B

10/100-TX Por ts (1-24)

Grab the screws and pull the module out from the slot. It may help to brace

your hands against the face of the switch and "lever" the module out from

the switch slot.

Do one of the following:

•

If you will be installing another module in the slot, go to "Installing

the Module in an Unused Slot" on page 5 and begin with step 2.

•

If you will not install another module in the slot (that is, leave it

empty), then re-install a slot cover plate over the empty slot opening.

For proper cooling and reduction of electromagnetic emissions, ensure that

a slot cover is installed on any unused slot.

Reset the switch, as described under "Resetting the Switch" on page 15,

if you are exchanging one type of module with a different type of module

in the same slot (for example, replacing a 10/100-TX GL Module with a

100/1000-T GL Module).

If you are replacing a module with another one of the same type in the

same slot, it is not necessary to reset the switch. The current configuration

for ports in that slot will apply to the new module.

unscrew the retaining screws

Link|Mode

all por ts are HP Auto-MDIX

module