HP ProCurve 1600M Manual de instalação - Página 13

5. Tighten the two retaining screws to hold the module in place. The retaining

screws should be secure but be careful to not overtighten them.

4. Verify the Module is Installed Correctly

Observe the Module Status, Self Test, and Fault LEDs on the front of the switch

to verify that the module is installed properly.

Module Status and

Self Test LED

Fault LED

When the module is installed properly and the switch is powered on, or the

module is installed when the switch already has power, the module undergoes

a self test that takes a few seconds. You can use the LEDs to determine that

the module is installed properly and has passed the self test, as described in

the "LED Behavior" table below.

LED Behavior

LED

Module Status

Self Test

Fault

Display for a Properly Installed Module

Goes ON as soon as the module is installed and the switch is

powered on, and stays ON steadily.

ON briefly while the module is being tested, then OFF.

Note: If the switch was powered off while the module was

installed, when the switch is powered on, the Self Test LED will

stay ON for the duration of the whole switch self test.

OFF

Installing the Module

tighten the two

retaining screws