HP ProCurve 1600M Suplemento ao manual - Página 13

Enter the Hello interval or leave the field unchanged to use the default. The software fills in the default after

you select Add. In this example, leave the field unchanged.

Select the mode (Owner or Backup). Select Owner in this example.

Select Enable to activate the VRRP entry after you select Add.

Enter the interface's IP address in the IP Address List field. In this example, enter 192.53.5.1.

Enter the virtual interface if applicable. (In this example, the VRRP interface is not defined on a virtual

interface.)

10. Select the track port. In this example, select 2/4.

11. Select Add to add the entry.

Figure 3

Configuration panel for owner

Configuring Router2 Using the Web Management Interface

To configure VRRP Router2 in Figure 2 after you enable VRRP:

Select VRRP from the System configuration sheet. The panel shown in Figure 4 appears.

NOTE: If you have already created VRRP definitions on the router, the VRRP Virtual Router panel is

displayed instead. In this case, click on Add VRRP Virtual Router.

Select the interface from the pulldown list on the Port field. In this example, select 1/5.

Enter the VRID in the Router ID field the Router ID field. In this example, use the default value, 1.

Enter the track priority or leave the field blank to use the default. In this example, enter 19.

Configuring VRRP