HP ProCurve 1600M Leia-me primeiro - Página 13

Procurar online ou descarregar pdf Leia-me primeiro para Interruptor HP ProCurve 1600M. HP ProCurve 1600M 16 páginas. Redundant power supply
Também para HP ProCurve 1600M: Ficha de especificações (12 páginas), Leia-me primeiro (8 páginas), Manual do revisor (27 páginas), Manual suplementar (2 páginas), Manual suplementar (2 páginas), Manual de instalação (28 páginas), Manual de instalação (36 páginas), Manual de instalação (28 páginas), Manual de configuração rápida (2 páginas), Manual de configuração rápida (4 páginas), Manual do utilizador (8 páginas), Suplemento ao manual (28 páginas), Instalação e remoção (2 páginas), Manual de instalação (12 páginas), Manual de planeamento e execução (40 páginas), Instruções de desmontagem do produto no fim da sua vida útil (2 páginas), Manual de instalação (46 páginas), Manual de diagnóstico (2 páginas), Instruções de desmontagem (2 páginas)

HP ProCurve 1600M Leia-me primeiro
Device Will Not Boot Up Due to Corrupt Operating System
Condition. The operating system (OS) is corrupt on both the primary and secondary flash memory, and the routing
switch will not boot up.
Solution. The routing switch will first try to boot up using the primary OS written to flash memory. If this fails, the
device automatically tries to boot from the secondary flash memory. If this also fails, the routing switch then tries to
connect to a TFTP server and boot from there. This will fail if a TFTP server is not configured to support the routing
switch, or is not found. You can perform this solution only if you have access to a TFTP server. Otherwise, there are
TFTP applications (available on the World Wide Web) that you can use to enable your PC to appear as a TFTP server
to the routing switch. One website where such software can be found is http://www.walusoft.co.uk.
1.
Using a straight-through cable, directly connect a PC or terminal to the serial port on the routing switch. (For
more information on attaching a PC or terminal, refer to chapter 2, "Installation", in the Quick Start Guide or
the Installation and Basic Configuration Guide.)
2.
Ensure that the OS version you want the switch to use is properly stored in your TFTP server.
3.
Reboot the routing switch as follows.
a.
Execute the reload command or use the (recessed) reset button on the management module.
1
Link
Active
b. Immediately after executing the boot command, enter Boot Monitor mode by pressing and holding the
key. You will then see this prompt:
BOOT MONITOR >
4.
Assign an IP address to the routing switch:
BOOT MONITOR > ip address < ip-address > < subnet-mask >
5.
If necessary, assign a default gateway IP address to the routing switch:
BOOT MONITOR > ip default_gateway < ip-address >
6.
Boot the switch using the OS you previously copied into the TFTP server:
BOOT MONITOR > boot system tftp < server-ip-address > < file-name >
The routing switch will now be able to boot up over the network. A new copy of the operating system can now be
downloaded to the primary and secondary flash memories via the TFTP server.
2
3
4
5
Link
Active
6
7
8
Link
Link
Active
Active
Console
Active
Pwr
Reset Button
[B]
13