Diamond Products CC190PRO Manual do operador - Página 12
Procurar online ou descarregar pdf Manual do operador para Serra Diamond Products CC190PRO. Diamond Products CC190PRO 16 páginas. Concrete saw
Imprimir página
CUT OF SAW IS SPALLING OR RAVELLING
Check bottom of skid plate for burrs
Check skid plate for excessive wear or gap around blade slot
Check if skid plate is bent.
Insure skid plate is mounted properly
Check to see if skid plate moves freely
Check lexan covers for free movement
Clean excess concrete from blade guard assembly
Check that front diverter in blade guard assembly is not bent. Diverter legs should not be contacting concrete
Check to see if both diverters in the blade block are not bent or binding
Insure blade guard shafts are not bent
Insure there is spring tension at each end of skip plate
Check to see if blade is damaged. Worn, warped, glazed or damaged blades in any way must be replaced
Insure the blade is properly mounted and secured.
Insure that the blade is the correct specification for the area
Insure that the concrete slab is in clean with no debris that could raise the skid plate or saw while cutting.
Insure joint protectors are used at all cut intersections.
Check belts and belt idler for proper tension.
.
Do not twist or move the saw sideways while cutting
Engine should be at full throttle and running properly
ENGINE RUNS ROUGH, BACK FIRES OR CAN NOT REACH FULL SPEED
.
Check to see if there is the correct fuel in the tank. Make sure there is not water in the fuel.
Check that the spark plugs are properly gapped and clean.
Insure that choke is in the "off" position after engine is warm.
See is air filter is not dirty or plugged.
Check that the throttle lever is properly set.
ENGINE WILL NOT START
Check if there is fuel in the tank and no water in the fuel
Check that the spark plug wires are connected to the spark plugs.
12