Diamondback 180 Manual de instalação - Página 2
Procurar online ou descarregar pdf Manual de instalação para Acessórios para automóveis Diamondback 180. Diamondback 180 2 páginas. For toyota tacoma 2005; toyota tacoma 2006; toyota tacoma 2007; toyota tacoma 2008; toyota tacoma 2009; toyota tacoma 2010; toyota tacoma 2011; toyota tacoma 2012; toyota tacoma 2013; toyota tacoma 2014; toyota tacoma 2015; toyota tacoma 2016; toyota taco
Também para Diamondback 180: Manual de instalação (2 páginas), Manual de instalação (2 páginas), Manual de instalação (2 páginas)
Imprimir páginaADJUST THE LOCK RODS
Use the 1/8" hex key to loosen the set screws on the linkages of the
9
forward lock rods.
Adjust the length of the forward lock rods and retighten the set
10
screws so that:
A. with the lock handles in the open position, the rod tips clear
the square-tube top rail or deck rail system and
B. with the handle in the closed position, the rod tips do not
strike the bulkhead.
ATTACH THE GAS SPRINGS
Attach the gas springs to the ball studs.
13
To avoid premature failure of your gas
springs, attach them barrel up, shaft down.
Leave the cover closed and locked for
14
24 hours to allow the weatherstrip
adhesive, which is pressure-sensitive,
to fully cure.
24 hours
Adhesive cure time
DiamondBackCovers.com
1/8" hex key
With the lock handle in the
11
closed position, position the
lock rods tight against the
underside of the square-tube
top rail or the deck rail system
so that they'll
draw the panels
down and com-
press the weath-
erstrip. Tighten
the rod guide
brackets with a
7/16" socket.
Double-check both panels to ensure they open, close, lock & seal
12
correctly. If at any point the weatherstrip does not touch the bed
rails, readjust the lock rods and mounting brackets as needed.
Your panels should be difficult to operate at first. After finishing
installation below, leave the panels closed as much as possible
for 3–4 days to break in the weatherstrip. After that period, you
should find that the panels open and close without difficulty.
7/16" socket
MAY 2017
JULY 2018