Olympus BX51 Manual de instruções - Página 10

Procurar online ou descarregar pdf Manual de instruções para Microscópio Olympus BX51. Olympus BX51 17 páginas. System
Também para Olympus BX51: Manual de instruções (40 páginas), Manual de instruções (34 páginas), Manual de instruções (37 páginas), Manual de instruções (11 páginas)

21. Examine specimen and document image if necessary:

22. When finished:

The prism control knob of the DIC slider.

Rotate the prism control knob of the DIC slider to obtain the background interference color that

can achieve maximum contrast according to the specimen under observation.

If the background color is black, darkfield-like observation can be performed.

If the background color is gray, a 3D-like image with maximum contrast with gray sensitive

gray can be obtained.

If the background color is sensitive magenta, even a minor optical retardation is observed as

a color change.

NOTE: Care should be taken to keep the specimen surface clean, as even a small amount of

contamination on the surface may show up due to the sensitivity of the DIC method.

This Manual: http://www.manuallib.com/file/2605418

If using 35mm film, use checklist for 'Olympus 35mm Camera'.

To obtain still digitized images, use checklist for 'Polaroid Digital Microscope

Camera (DMC).

To obtain still digitized images and digitized movies, use checklist for 'Sony, color

Video camera'.

Lower the stage by turning the focus knob (10) towards you and remove the slide

with your specimen from the stage (7).

Turn the nosepiece (12) back until the 10x objective is into place.

If the100x objective was used, clean the lens carefully with lens paper ONLY (do

not use Kimwhipes).

Rotate the condenser turret (23) until the BF (brightfield) mark is visible.

Loosen the clamping knob from the DIC prism slider and disengage the transmitted

light DIC prism slider (26) from the light path.

Pull the polarizer (25) out of the light path.

Pull the reflected light analyser (U-AN) (24) out of the light path.

Turn the light intensity down using the brightness adjustment knob (3).

Turn off the halogen light switch (1) to "0" (OFF).

Cover the microscope.

Leave the room CLEAN and TIDY!