Olympus BX61 Manual de instruções - Página 26

Procurar online ou descarregar pdf Manual de instruções para Microscópio Olympus BX61. Olympus BX61 40 páginas. Motorized system microscopes

Imprimir página

TROUBLESHOOTING GUIDE

Under certain conditions, performance of the unit may be adversely affected by factors other than defects. If problems occur,

please review the following list and take remedial action as needed. If you cannot solve the problem after checking the

entire list, please contact your local Olympus representative for assistance.

Problem

1. Optical System

a) Bulb does not light.

b) Bulb operates, but field of view re-

mains dark.

c) Field of view is obscured or not

evenly illuminated

d) Dirt or dust is visible in the field of

view.

e) Visibility is poor.

· Image is not sharp.

· Contrast is poor.

· Details are indistinct.

· Image glares.

Cause

Power cord of BX-UCB is unplugged.

Main switch of BX-UCB is not on.

Lamp ON-OFF switch on the base of

BX61 is not on.

Bulb is burned out.

Transmitted/reflected light switch is set

to reflected light (

Aperture and field iris diaphragms are not

opened wide enough.

Condenser is lowered too much.

Light path selector knob is set to the

position.

Light path selector knob is in an posi-

tioned halfway.

Revolving nosepiece is not correctly en-

gaged.

Condenser is not attached properly.

Revolving nosepiece is not attached

properly.

An objective that falls outside of the

condenser's illumination range is used.

Condenser is not properly centered.

Field iris diaphragm is stopped down too

far.

Bulb is not mounted correctly.

Dirt/dust on the eyepiece

Dirt or the to surface of the condenser

Dirt/dust on the specimen

A non-UIS2/UIS objective is used.

Condenser is lowered too far.

Aperture iris diaphragm is stopped down

too far.

Revolving nosepiece is not mounted

properly.

Remedy

Insert power plug firmly into power

outlet.

Set main switch to " I " (ON).

Set the lamp ON-OFF switch to ON.

Replace bulb with a new specified

bulb.

Set the switch to

(transmitted light

illumination).

Adjust them to proper sizes.

Adjust the condenser height position.

Move the knob to the

tion.

Set the knob according to the obser-

vation method.

Make sure that the revolving nose-

piece clicks properly into place.

Re-attach it.

Push the side dovetail all the way un-

til it is stopped.

Use a condenser to match the pur-

pose.

Center the condenser.

Open the field iris diaphragm until it

circumscribes the field.

Push the pins of halogen bulb all the

way until the stop position.

Clean thoroughly.

Use only UIS2/UIS series objectives

with this microscope.

Adjust the condenser height position.

Open aperture iris diaphragm.

Push the slide dovetail all the way until

it is stopped.

Page

–

19/20

posi-

–

27/28

–