Olympus SZX7 Manual de instruções - Página 26

Procurar online ou descarregar pdf Manual de instruções para Microscópio Olympus SZX7. Olympus SZX7 32 páginas. Stereomicroscope system
Também para Olympus SZX7: Manual de instruções (32 páginas)

Imprimir página

External View and Nomenclature

Stage

Load capacity: 1 kg

Clamping knob

Installation

1. Using the provided screw and Allen wrench, attach the SZ2-FO up/down moving stage into the screw hole on the stage

plate mount hole of an applicable stand or that on the stage plate (SZ-STL).

The SZ2-FO can also be installed so that the focus adjustment knobs are located on the near side of the operator. This

orientation is obligatory when the IHE holder for the LSGA oblique illumination system is used.

2. Loosen the clamping knob on the stage, attach the stage plate, SZH-SG or SZH-SC, and tighten the clamping knob again.

Operation

Push up.

Clamp.

Clamping screw holes

Fig. 19

}This operation is intended to facilitate the rotation of the knobs while

To increase

1. Hold the left and right focus adjustment knobs @ with both hands, fix the

To decrease

2. If the rotation tension is increased too much, accurate focusing is not

Fig. 20

Removing the stage plate (Fig. 19)

To remove the stage plate, loosen the clamping knob @ and push up

the stage plate from below it.

Adjusting the focus adjustment knob tension (Fig. 20)

preventing spontaneous drop of the up/down moving stage. It is

recommended to set the knob tension to a slightly higher level than the

point where spontaneous drop occurs.

left knob and rotate the right knob. The rotation tension of the knobs

increases or decreases according to the direction in which the right knob

is rotated.

possible and the mechanism may be damaged.

Focus adjustment knobs

Stroke: Approx. 21 mm

Rotation tension adjustable.