Olympus SZX7 Руководство по эксплуатации - Страница 26
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Микроскоп Olympus SZX7. Olympus SZX7 32 страницы. Stereomicroscope system
Также для Olympus SZX7: Руководство по эксплуатации (32 страниц)
Печатать страницу
2
External View and Nomenclature
Stage
Load capacity: 1 kg
Clamping knob
3
Installation
1. Using the provided screw and Allen wrench, attach the SZ2-FO up/down moving stage into the screw hole on the stage
plate mount hole of an applicable stand or that on the stage plate (SZ-STL).
The SZ2-FO can also be installed so that the focus adjustment knobs are located on the near side of the operator. This
orientation is obligatory when the IHE holder for the LSGA oblique illumination system is used.
2. Loosen the clamping knob on the stage, attach the stage plate, SZH-SG or SZH-SC, and tighten the clamping knob again.
4
Operation
1
Push up.
Clamp.
23
Clamping screw holes
Fig. 19
}This operation is intended to facilitate the rotation of the knobs while
To increase
1
1. Hold the left and right focus adjustment knobs @ with both hands, fix the
To decrease
2. If the rotation tension is increased too much, accurate focusing is not
Fig. 20
Removing the stage plate (Fig. 19)
To remove the stage plate, loosen the clamping knob @ and push up
the stage plate from below it.
Adjusting the focus adjustment knob tension (Fig. 20)
preventing spontaneous drop of the up/down moving stage. It is
recommended to set the knob tension to a slightly higher level than the
point where spontaneous drop occurs.
left knob and rotate the right knob. The rotation tension of the knobs
increases or decreases according to the direction in which the right knob
is rotated.
possible and the mechanism may be damaged.
Focus adjustment knobs
Stroke: Approx. 21 mm
Rotation tension adjustable.