Arcam DiVA A85 Manual - Página 7

Procurar online ou descarregar pdf Manual para Amplificador Arcam DiVA A85. Arcam DiVA A85 14 páginas.

Imprimir página

Recording

With the Arcam A85 it is possible to listen to and record from

one source, or to listen to one source while recording another.

Both sets of tape sockets are identical in sensitivity and

suitable for use with almost any type of recorder (cassette,

CDR, MD, VCR, reel-to-reel, etc.). The record signal is sent to

both the

and

output sockets.

TAPE

VCR

RECORD

To record the currently selected source, press

the display shows '

the display reverts to showing the volume level and you are

ready to record.

To listen to one source while recording another, press

again until the display shows '

of an input (e.g. '

', '

source selector button on the front panel for the source you

wish to record. Your selection is shown on the display for a few

seconds, after which it reverts to showing the volume level and

you are ready to record.

The

button can also be used as a second zone

RECORD

selector, sending a source signal at line level to a second

ampliﬁ er operating in another room. If you need help with this,

contact your Arcam dealer or Arcam customer support.

Tape-to-tape copying (dubbing)

You can perform tape dubbing from

TAPE

VCR

For example, to copy from a cassette recorder connected to

the VCR socket to a cassette recorder connected to the TAPE 1

socket, ﬁ rst use the

button as explained above and

RECORD

select '

'. This routes the VCR signal to the TAPE

output.

Set the cassette recorder connected to the

record mode and the other to playback mode to start dubbing.

TAPE

To play back the recording from a cassette deck attached

to the TAPE 1 input, press

. '

TAPE

the display. Selecting this input overrides the other source

selectors.

It is also possible to monitor a recording while it is being made,

provided your cassette deck is a 3-head type. To do this, press

. Switching this button in/out allows an A/B comparison

TAPE

between the source signal and the recorded signal.

until

RECORD

'. After a few seconds

RECORD

' followed by the name

', etc.). Now press the

, but not from

VCR

TAPE

socket into its

TAPE

' is shown on

A85/P85