ARCHITETTURA SONORA CUBE400 Manual de serviço - Página 5
Procurar online ou descarregar pdf Manual de serviço para Altifalantes ARCHITETTURA SONORA CUBE400. ARCHITETTURA SONORA CUBE400 6 páginas.
Imprimir página
3.6 > Turn a Subwoofer Cube into a Fullrange Cube:
1 > 2
Follow steps
of "1.0 Disassembly Procedure" then follow these steps:
3 >
unscrew the 4 M5X30 screws and
remove the stainless steel frame
protecting
subwoofer remains untied as well.
y
1 > 9
Then follow steps
of "2.0 Assembly Procedure" to nish the operation.
Grower
washer (I)
Flat steel
washer (L)
Red ber
M10
washer (M)
screw (H)
10 >
Overturn the subwoofer on the
internal ange, matching the holes in the
basket with the holes in the inner ange.
Position
the
loudspeaker
frame, paying attention to an extreme
coincide with the holes of the speaker.
Using the Allen key #3 (B) turn the four M5
screws counter-clockwise until you hear a
click that indicates the correct insertion of
the rst thread of the screw in the threa-
ded seat. Then tighten the screws by
turning clockwise crosswise (always
tighten the screw opposite to the previous
one) until you start feeling resistance.
12 >
Tighten the four screws M10
(always crosswise) with the torque
wrench #7(E) set at 12 N.m.
Then insert the thermo-shrinking
sheath, about 40 mm long, along the
cable where it comes out from the
base and heat it with the hot air gun
(G) at a temperature about 280°C.
WARNING:
do
not
exceed
recommended temperature in order
to prevent the fusion of the cable.
Using the Allen Key #3(B)
the
subwoofer.
-
white
+
LF
y
brown
-
LF
green
protection
the
The
+
5 >
Open the Crossover box with the Phillips screwdriver
brown
(C), insert the bipolar and quadripolar cables and solder the
six connections using the welder (F). Remember the phases.
Fasten the sealed cable glands (
wrenches #17 (D) to secure the cables.
+
HF
yellow
-
HF
white
11 >
Insert the cable in the through
column of the base and at the same time
place the base on the Cube taking extre-
me care not to scratch the frame below.
IMPORTANT: the cable was previously laid
into the appropriate groove present on the
Cube's body and sealed with silicone.
Place the 4 M10 screws (H), the "Grower"
(L), the at stainless steel and the red ber
washers in the holes of the base with the
red one in contact with the base then the
at steel one, then "grower" and nally the
screw.
Using the Allen key #7 (B) turn the four M5
screws counter-clockwise until you hear a
click that indicates the correct insertion of
the rst thread of the screw in the threaded
seat. Then tighten the screws by turning
clockwise crosswise (always tighten the
screw opposite to the previous one) until
you start feeling resistance.
13 >
Turn the Cube upside-down
back on its base, following the
Instruction Manual directions.
4 >
Lift the sub and turn it over the
inner ange of the Cube. Desolder the
bipolar cable from the two connections
on the subwoofer, quickly enough to
avoid thermal damage to wires and
internal connections of the driver.
Remove the subwoofer.
y
) using the two at